Low Pressure in line pre fuel pump or pre carb filter kit

£4.00

6mm Inline fuel filter, 2 lengths of Fuel Hose (27 cm each length) and 4 Jubilee Clips

This filter is a steel mesh type high quality straining filter and is suitable for use as a pre or post-pump filter when used with any pump that matches the sizes shown.  Due to the mesh type design of this filter the gravity feed from the tank to the pump is not restricted and will not interfere with the fuel flow unlike some filters. These filters filter down to 100 microns (0.1mm) and the units themselves measure 43mm in width and 53mm in length, so are a good small size. The hose ends are 6mm Dia so suitable for 6mm or 7mm hose and the hose ends are 21mm long.

99% of fuel pump failures or carb problems are caused by contamination from dirt pulled in from the tank or to the carbs. With the cost of a new pump being the only cure it's false economy not spending the extra and fitting a pre-filter.


Add to Cart:

  • Model: FP_filter
  • Shipping Weight: 0.2kgs
  • 1201 Units in Stock

Ask a Question About This Product
Do you like this product? Share it with your friends:

Copyright © 2018 Powerspark Website Support. Powered by www.simonbbc.com